[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH] migratioin/ram.c: reset complete_round when we
From: |
Wei Yang |
Subject: |
Re: [Qemu-devel] [PATCH] migratioin/ram.c: reset complete_round when we gets a queued page |
Date: |
Wed, 5 Jun 2019 16:52:07 +0800 |
User-agent: |
Mutt/1.10.1 (2018-07-13) |
On Wed, Jun 05, 2019 at 02:41:08PM +0800, Peter Xu wrote:
>On Wed, Jun 05, 2019 at 09:08:28AM +0800, Wei Yang wrote:
>> In case we gets a queued page, the order of block is interrupted. We may
>> not rely on the complete_round flag to say we have already searched the
>> whole blocks on the list.
>>
>> Signed-off-by: Wei Yang <address@hidden>
>> ---
>> migration/ram.c | 6 ++++++
>> 1 file changed, 6 insertions(+)
>>
>> diff --git a/migration/ram.c b/migration/ram.c
>> index d881981876..e9b40d636d 100644
>> --- a/migration/ram.c
>> +++ b/migration/ram.c
>> @@ -2290,6 +2290,12 @@ static bool get_queued_page(RAMState *rs,
>> PageSearchStatus *pss)
>> */
>> pss->block = block;
>> pss->page = offset >> TARGET_PAGE_BITS;
>> +
>> + /*
>> + * This unqueued page would break the "one round" check, even is
>> + * really rare.
>
>Why this is needed? Could you help explain the problem first?
Peter, Thanks for your question.
I found this issue during code review and I believe this is a corner case.
Below is a draft chart for ram_find_and_save_block:
ram_find_and_save_block
do
get_queued_page()
find_dirty_block()
ram_save_host_page()
while
The basic logic here is : get a page need to migrate and migrate it.
In case we don't have get_queued_page(), find_dirty_block() will search the
whole ram_list.blocks by order. pss->complete_round is used to indicate
whether this search has looped.
Everything works fine after get_queued_page() involved. The block unqueued in
get_queued_page() could be any block in the ram_list.blocks. This means we
have very little chance to break the looped indicator.
unqueue_page() last_seen_block
| |
ram_list.blocks v v
---------------------------------+=====+---
Just draw a raw picture to demonstrate a corner case.
For example, we start from last_seen_block and search till the end of
ram_list.blocks. At this moment, pss->complete_round is set to true. Then we
get a queued page from unqueue_page() at the point I pointed. So the loop
continues may just continue the range as I marked as "=". We will skip all the
other ranges.
This is really a corner case, since ram_save_host_page() should return 0 and
there should be no dirty page in this range. But I don't see we may avoid this
case.
If I am not correct, just let me know :-)
>
>Thanks,
>
>--
>Peter Xu
--
Wei Yang
Help you, Help me
Re: [Qemu-devel] [PATCH] migratioin/ram.c: reset complete_round when we gets a queued page, Philippe Mathieu-Daudé, 2019/06/05