[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PATCH] audio: add -audiodev pa,in|out.latency= to documentation
From: |
Stefan Hajnoczi |
Subject: |
[PATCH] audio: add -audiodev pa,in|out.latency= to documentation |
Date: |
Fri, 4 Oct 2019 13:56:41 +0100 |
The "latency" parameter wasn't covered by the documentation.
Signed-off-by: Stefan Hajnoczi <address@hidden>
---
Hi Gerd,
You asked me to resend this patch because there was a conflict. I have
rebased it onto qemu.git/master (4f59102571fc).
qemu-options.hx | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/qemu-options.hx b/qemu-options.hx
index 2a04ca6ac5..5c27c57273 100644
--- a/qemu-options.hx
+++ b/qemu-options.hx
@@ -470,6 +470,7 @@ DEF("audiodev", HAS_ARG, QEMU_OPTION_audiodev,
"-audiodev pa,id=id[,prop[=value][,...]]\n"
" server= PulseAudio server address\n"
" in|out.name= source/sink device name\n"
+ " in|out.latency= desired latency in microseconds\n"
#endif
#ifdef CONFIG_AUDIO_SDL
"-audiodev sdl,id=id[,prop[=value][,...]]\n"
@@ -630,6 +631,10 @@ Sets the PulseAudio @var{server} to connect to.
@item in|out.name=@var{sink}
Use the specified source/sink for recording/playback.
+@item in|out.latency=@var{usecs}
+Desired latency in microseconds. The PulseAudio server will try to honor this
+value but actual latencies may be lower or higher.
+
@end table
@item -audiodev sdl,id=@var{id}[,@var{prop}[=@var{value}][,...]]
--
2.21.0
- [PATCH] audio: add -audiodev pa,in|out.latency= to documentation,
Stefan Hajnoczi <=