[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH v2 0/1] 9pfs: log warning if msize <= 8192
From: |
Christian Schoenebeck |
Subject: |
Re: [PATCH v2 0/1] 9pfs: log warning if msize <= 8192 |
Date: |
Thu, 03 Sep 2020 17:48:33 +0200 |
On Donnerstag, 3. September 2020 17:41:23 CEST Greg Kurz wrote:
> On Thu, 3 Sep 2020 17:19:31 +0200
>
> Greg Kurz <groug@kaod.org> wrote:
> > On Thu, 3 Sep 2020 16:41:02 +0200
> >
> > Christian Schoenebeck <qemu_oss@crudebyte.com> wrote:
> > > I have updated the QEMU 9P setup wiki page about this 'msize' issue. For
> > > some reason the dedicated anchor 'msize' does not work though:
> > >
> > > https://wiki.qemu.org/Documentation/9psetup#msize
> >
> > AFAICT the wiki derives the anchor from the section name, ie.
> >
> > https://wiki.qemu.org/Documentation/9psetup#Performance_Considerations
> >
> > It's a bit longer than #msize but it works. I don't know if you can
> > add anchors manually in the wiki.
>
> It seems you could achieve this without the template:
>
> == <span id="msize">Performance Considerations</span> ==
What I tried was this (as wiki source):
<!-- NOTE: anchor 'msize' is linked by a QEMU 9pfs log message in 9p.c -->
{{anchor|msize}}
== Performance Considerations ==
Which "should" work according to:
https://en.wikipedia.org/wiki/Template:Anchor
However after I did those changes I saw some template errors as comment in the
generated HTML sources, which now are gone at least.
I wait a bit to see if it is maybe just a caching problem. If it still doesn't
work in a while, I will update it with your solution a bit later.
Thanks for the hint!
Best regards,
Christian Schoenebeck