RE: [PATCH v1 1/3] i386: Remove the limitation of IP payloads for Intel PT

[Kang, Luwei]

> > > >>>> No, it's not possible.  KVM doesn't have a say on what the
> > > >>>> processor writes in the tracing packets.
> > > >>> Can KVM refuse to enable packet generation if CSbase is not zero
> > > >>> and CPUID.(EAX=14H,ECX=0)[bit 31] seen by guest is different from
> host?
> > > >>
> > > >> Yes, but the processor could change operating mode (and hence
> > > >> CSbase) while tracing is active.  This is very unlikely, since it
> > > >> would require nonzero CS-base and a 32-bit host, but in principle
> > > >> not impossible (could be a firmware call, for example).
> > > >>
> > > >> The only solution is for KVM to accept both, and for QEMU to
> > > >> refuse a setting that does not match the host.
> > > >>
> > > >
> > > > So I need to add a patch in KVM to disabled the Intel PT when the
> > > > CSbase is not zero and the guest LIP different from the host. And
> > > > this limitation in qemu (disabled the PT when LIP is enabled in
> > > > the host) can be remove. Is that right?
> > >
> > > No, if a feature cannot be emulated, that means it cannot be enabled
> > > unless it matches the host.  That's generally not a problem since
> > > Intel PT is usually used only with "-cpu host".
> > >
> >
> > The limitation of LIP in qemu will mask off the Intel PT in KVM guest
> > even with "-cpu host". e.g. This bit will be set in SnowRidge HW and
> > later.
> 
> This behavior can and should be changed.
> 
> >
> > How about "-cpu cpu_model, +intel-pt" use case? The current value of
> > Intel PT CPUID is a constant. Can we make the ICX CPUID as basic
> > inforation(LIP is 0) and using "+intel-pt-lip"
> > to make Intel PT work on the CPU which LIP is 1 on the host? As you
> > mentioned before, Intel PT cannot be enabled in guest unless it
> > matches the host.
> 
> This makes sense, but you can also make each CPU model set a default for the
> LIP bit.  "-cpu SnowRidge,+intel-pt" could set
> LIP=1 by default.

I have a question on how to set LIP=1 in SnowRidge by default. 
1. Set LIP in "builtin_x86_defs[]" SnowRidge CPU model. The LIP included in 
CPUID.(eax=14x,ecx=0)ecx[bit31] and a new leaf needs to be added.
2. Checking the CPU model in the later software flow and set the LIP bit if the 
CPU model is Snowridge. And we also need to add more CPU model's checking for 
new CPUs.

What is your opinion?

Thanks,
Luwei Kang

> 
> --
> Eduardo