Re: [RFC PATCH] hw/misc/zynq_slcr: Avoid #DIV/0! error

[Alistair Francis]

On Thu, Dec 10, 2020 at 6:27 AM Philippe Mathieu-Daudé <f4bug@amsat.org> wrote:
>
> Malicious user can set the feedback divisor for the PLLs
> to zero, triggering a floating-point exception (SIGFPE).
>
> As the datasheet [*] is not clear how hardware behaves
> when these bits are zeroes, use the maximum divisor
> possible (128) to avoid the software FPE.
>
> [*] Zynq-7000 TRM, UG585 (v1.12.2)
>     B.28 System Level Control Registers (slcr)
>     -> "Register (slcr) ARM_PLL_CTRL"
>     25.10.4 PLLs
>     -> "Software-Controlled PLL Update"
>
> Fixes: 38867cb7ec9 ("hw/misc/zynq_slcr: add clock generation for uarts")
> Reported-by: Gaoning Pan <pgn@zju.edu.cn>
> Signed-off-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
> ---
> Cc: Damien Hedde <damien.hedde@greensocs.com>
> Cc: Edgar E. Iglesias <edgar.iglesias@xilinx.com>
> Cc: Alistair Francis <alistair.francis@wdc.com>
> Cc: Gaoning Pan <gaoning.pgn@antgroup.com>
> Cc: Mauro Matteo Cascella <mcascell@redhat.com>
>
> Alternative is to threat that as PLL disabled and return 0...

I'm not sure which is better, but this patch now is better then before:

Reviewed-by: Alistair Francis <alistair.francis@wdc.com>

Alistair

> ---
>  hw/misc/zynq_slcr.c | 5 +++++
>  1 file changed, 5 insertions(+)
>
> diff --git a/hw/misc/zynq_slcr.c b/hw/misc/zynq_slcr.c
> index a2b28019e3c..66504a9d3ab 100644
> --- a/hw/misc/zynq_slcr.c
> +++ b/hw/misc/zynq_slcr.c
> @@ -217,6 +217,11 @@ static uint64_t zynq_slcr_compute_pll(uint64_t input, 
> uint32_t ctrl_reg)
>          return 0;
>      }
>
> +    /* Consider zero feedback as maximum divide ratio possible */
> +    if (!mult) {
> +        mult = 1 << R_xxx_PLL_CTRL_PLL_FPDIV_LENGTH;
> +    }
> +
>      /* frequency multiplier -> period division */
>      return input / mult;
>  }
> --
> 2.26.2
>
>