[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH 3/3] hw/arm: sabrelite: Connect the Ethernet PHY at address 6
From: |
Bin Meng |
Subject: |
Re: [PATCH 3/3] hw/arm: sabrelite: Connect the Ethernet PHY at address 6 |
Date: |
Mon, 14 Dec 2020 18:50:14 +0800 |
On Mon, Dec 14, 2020 at 6:42 PM Alex Bennée <alex.bennee@linaro.org> wrote:
>
>
> Bin Meng <bmeng.cn@gmail.com> writes:
>
> > From: Bin Meng <bin.meng@windriver.com>
> >
> > At present, when booting U-Boot on QEMU sabrelite, we see:
> >
> > Net: Board Net Initialization Failed
> > No ethernet found.
> >
> > U-Boot scans PHY at address 4/5/6/7 (see board_eth_init() in the
> > U-Boot source: board/boundary/nitrogen6x/nitrogen6x.c). On the real
> > board, the Ethernet PHY is at address 6. Adjust this by updating the
> > "fec-phy-num" property of the fsl_imx6 SoC object.
> >
> > With this change, U-Boot sees the PHY but complains MAC address:
> >
> > Net: using phy at 6
> > FEC [PRIME]
> > Error: FEC address not set.
> >
> > This is due to U-Boot tries to read the MAC address from the fuse,
> > which QEMU does not have any valid content filled in. However this
> > does not prevent the Ethernet from working in QEMU. We just need to
> > set up the MAC address later in the U-Boot command shell, by:
> >
> > => setenv ethaddr 00:11:22:33:44:55
> >
> > Signed-off-by: Bin Meng <bin.meng@windriver.com>
>
> Reviewed-by: Alex Bennée <alex.bennee@linaro.org>
>
Thanks for the review.
> As you are giving this board some attention is there any chance you
> could be persuaded to add an entry in docs/system/arm (linked from
> docs/system/target-arm.rst) to briefly describe the board and what is
> known to work and boot on it?
Sure, I will try to add something for this board in v2.
Regards,
Bin