[PULL 02/13] qemu-storage-daemon: Only display FUSE help when FUSE is built-in

[Kevin Wolf]

From: Philippe Mathieu-Daudé <philmd@redhat.com>

When configuring QEMU with --disable-fuse, the qemu-storage-daemon
still reports FUSE command line options in its help:

  $ qemu-storage-daemon -h
  Usage: qemu-storage-daemon [options]
  QEMU storage daemon

    --export [type=]fuse,id=<id>,node-name=<node-name>,mountpoint=<file>
             [,growable=on|off][,writable=on|off]
                           export the specified block node over FUSE

Remove this help message when FUSE is disabled, to avoid:

  $ qemu-storage-daemon --export fuse
  qemu-storage-daemon: --export fuse: Invalid parameter 'fuse'

Reported-by: Qing Wang <qinwang@redhat.com>
Signed-off-by: Philippe Mathieu-Daudé <philmd@redhat.com>
Message-Id: <20210816180442.2000642-1-philmd@redhat.com>
Reviewed-by: Eric Blake <eblake@redhat.com>
Reviewed-by: Hanna Reitz <hreitz@redhat.com>
Signed-off-by: Kevin Wolf <kwolf@redhat.com>
---
 storage-daemon/qemu-storage-daemon.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/storage-daemon/qemu-storage-daemon.c 
b/storage-daemon/qemu-storage-daemon.c
index fc8b150629..10a1a33761 100644
--- a/storage-daemon/qemu-storage-daemon.c
+++ b/storage-daemon/qemu-storage-daemon.c
@@ -98,10 +98,12 @@ static void help(void)
 "                         export the specified block node over NBD\n"
 "                         (requires --nbd-server)\n"
 "\n"
+#ifdef CONFIG_FUSE
 "  --export [type=]fuse,id=<id>,node-name=<node-name>,mountpoint=<file>\n"
 "           [,growable=on|off][,writable=on|off]\n"
 "                         export the specified block node over FUSE\n"
 "\n"
+#endif /* CONFIG_FUSE */
 "  --monitor [chardev=]name[,mode=control][,pretty[=on|off]]\n"
 "                         configure a QMP monitor\n"
 "\n"
-- 
2.31.1