[PULL 03/39] scsi: Reject commands if the CDB length exceeds buf_len

[Paolo Bonzini]

From: John Millikin <john@john-millikin.com>

In scsi_req_parse_cdb(), if the CDB length implied by the command type
exceeds the initialized portion of the command buffer, reject the request.

Rejected requests are recorded by the `scsi_req_parse_bad` trace event.

On example of a bug detected by this check is SunOS's use of interleaved
DMA and non-DMA commands. This guest behavior currently causes QEMU to
parse uninitialized memory as a SCSI command, with unpredictable
outcomes.

With the new check in place:

  * QEMU consistently creates a trace event and rejects the request.

  * SunOS retries the request(s) and is able to successfully boot from
    disk.

Signed-off-by: John Millikin <john@john-millikin.com>
Resolves: https://gitlab.com/qemu-project/qemu/-/issues/1127
Message-Id: <20220817053458.698416-2-john@john-millikin.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
---
 hw/scsi/scsi-bus.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/hw/scsi/scsi-bus.c b/hw/scsi/scsi-bus.c
index cc71524024..4403717c4a 100644
--- a/hw/scsi/scsi-bus.c
+++ b/hw/scsi/scsi-bus.c
@@ -712,6 +712,11 @@ SCSIRequest *scsi_req_new(SCSIDevice *d, uint32_t tag, 
uint32_t lun,
     SCSICommand cmd = { .len = 0 };
     int ret;
 
+    if (buf_len == 0) {
+        trace_scsi_req_parse_bad(d->id, lun, tag, 0);
+        goto invalid_opcode;
+    }
+
     if ((d->unit_attention.key == UNIT_ATTENTION ||
          bus->unit_attention.key == UNIT_ATTENTION) &&
         (buf[0] != INQUIRY &&
@@ -741,6 +746,7 @@ SCSIRequest *scsi_req_new(SCSIDevice *d, uint32_t tag, 
uint32_t lun,
 
     if (ret != 0) {
         trace_scsi_req_parse_bad(d->id, lun, tag, buf[0]);
+invalid_opcode:
         req = scsi_req_alloc(&reqops_invalid_opcode, d, tag, lun, hba_private);
     } else {
         assert(cmd.len != 0);
@@ -1316,7 +1322,7 @@ int scsi_req_parse_cdb(SCSIDevice *dev, SCSICommand *cmd, 
uint8_t *buf,
 
     cmd->lba = -1;
     len = scsi_cdb_length(buf);
-    if (len < 0) {
+    if (len < 0 || len > buf_len) {
         return -1;
     }
 
-- 
2.37.2