[Stable-8.1.1 25/34] hw/ide/ahci: PxSACT and PxCI is cleared when PxCMD.ST is cleared

[Michael Tokarev]

From: Niklas Cassel <niklas.cassel@wdc.com>

According to AHCI 1.3.1 definition of PxSACT:
This field is cleared when PxCMD.ST is written from a '1' to a '0' by
software. This field is not cleared by a COMRESET or a software reset.

According to AHCI 1.3.1 definition of PxCI:
This field is also cleared when PxCMD.ST is written from a '1' to a '0'
by software.

Clearing PxCMD.ST is part of the error recovery procedure, see
AHCI 1.3.1, section "6.2 Error Recovery".

If we don't clear PxCI on error recovery, the previous command will
incorrectly still be marked as pending after error recovery.

Signed-off-by: Niklas Cassel <niklas.cassel@wdc.com>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20230609140844.202795-6-nks@flawful.org
Signed-off-by: John Snow <jsnow@redhat.com>
(cherry picked from commit d73b84d0b664e60fffb66f46e84d0db4a8e1c713)
Signed-off-by: Michael Tokarev <mjt@tls.msk.ru>

diff --git a/hw/ide/ahci.c b/hw/ide/ahci.c
index 3deaf01add..a31e6fa65e 100644
--- a/hw/ide/ahci.c
+++ b/hw/ide/ahci.c
@@ -329,6 +329,11 @@ static void ahci_port_write(AHCIState *s, int port, int 
offset, uint32_t val)
         ahci_check_irq(s);
         break;
     case AHCI_PORT_REG_CMD:
+        if ((pr->cmd & PORT_CMD_START) && !(val & PORT_CMD_START)) {
+            pr->scr_act = 0;
+            pr->cmd_issue = 0;
+        }
+
         /* Block any Read-only fields from being set;
          * including LIST_ON and FIS_ON.
          * The spec requires to set ICC bits to zero after the ICC change
-- 
2.39.2