[PULL 19/19] hw/i2c/imx_i2c: Always set interrupt status bit if interrupt condition occurs

[Philippe Mathieu-Daudé]

From: Bernhard Beschow <shentey@gmail.com>

According to the i.MX 8M Plus reference manual, the status flag I2C_I2SR[IIF]
continues to be set when an interrupt condition occurs even when I2C interrupts
are disabled (I2C_I2CR[IIEN] is clear). However, the device model only sets the
flag when I2C interrupts are enabled which causes U-Boot to loop forever. Fix
the device model by always setting the flag and let I2C_I2CR[IIEN] guard I2C
interrupts only.

Also remove the comment in the code since it merely stated the obvious and would
be outdated now.

Cc: qemu-stable@nongnu.org
Fixes: 20d0f9cf6a41 ("i.MX: Add I2C controller emulator")
Signed-off-by: Bernhard Beschow <shentey@gmail.com>
Acked-by: Corey Minyard <cminyard@mvista.com>
Message-ID: <20250507124040.425773-1-shentey@gmail.com>
Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
---
 hw/i2c/imx_i2c.c | 11 +++++------
 1 file changed, 5 insertions(+), 6 deletions(-)

diff --git a/hw/i2c/imx_i2c.c b/hw/i2c/imx_i2c.c
index 91f84c2ad7d..d26177c85df 100644
--- a/hw/i2c/imx_i2c.c
+++ b/hw/i2c/imx_i2c.c
@@ -79,13 +79,12 @@ static void imx_i2c_reset(DeviceState *dev)
 
 static inline void imx_i2c_raise_interrupt(IMXI2CState *s)
 {
-    /*
-     * raise an interrupt if the device is enabled and it is configured
-     * to generate some interrupts.
-     */
-    if (imx_i2c_is_enabled(s) && imx_i2c_interrupt_is_enabled(s)) {
+    if (imx_i2c_is_enabled(s)) {
         s->i2sr |= I2SR_IIF;
-        qemu_irq_raise(s->irq);
+
+        if (imx_i2c_interrupt_is_enabled(s)) {
+            qemu_irq_raise(s->irq);
+        }
     }
 }
 
-- 
2.47.1