Re: [PATCH] goldfish_rtc: Fix non-atomic read behaviour of TIME_LOW/TIME_HIGH

[Richard Henderson]

On 7/17/20 5:20 PM, Jessica Clarke wrote:
> The specification says:
> 
>    0x00  TIME_LOW   R: Get current time, then return low-order 32-bits.
>    0x04  TIME_HIGH  R: Return high 32-bits from previous TIME_LOW read.
> 
>    ...
> 
>    To read the value, the kernel must perform an IO_READ(TIME_LOW),
>    which returns an unsigned 32-bit value, before an IO_READ(TIME_HIGH),
>    which returns a signed 32-bit value, corresponding to the higher half
>    of the full value.
> 
> However, we were just returning the current time for both. If the guest
> is unlucky enough to read TIME_LOW and TIME_HIGH either side of an
> overflow of the lower half, it will see time be in the future, before
> jumping backwards on the next read, and Linux currently relies on the
> atomicity guaranteed by the spec so is affected by this. Fix this
> violation of the spec by caching the correct value for TIME_HIGH
> whenever TIME_LOW is read, and returning that value for any TIME_HIGH
> read.
> 
> Signed-off-by: Jessica Clarke <jrtc27@jrtc27.com>
> ---
>  hw/rtc/goldfish_rtc.c         | 14 ++++++++++++--
>  include/hw/rtc/goldfish_rtc.h |  1 +
>  2 files changed, 13 insertions(+), 2 deletions(-)
> 
> diff --git a/hw/rtc/goldfish_rtc.c b/hw/rtc/goldfish_rtc.c
> index 01e9d2b083..9b577bf159 100644
> --- a/hw/rtc/goldfish_rtc.c
> +++ b/hw/rtc/goldfish_rtc.c
> @@ -94,12 +94,22 @@ static uint64_t goldfish_rtc_read(void *opaque, hwaddr 
> offset,
>      GoldfishRTCState *s = opaque;
>      uint64_t r = 0;
>  
> +    /*
> +     * From the documentation linked at the top of the file:
> +     *
> +     *   To read the value, the kernel must perform an IO_READ(TIME_LOW), 
> which
> +     *   returns an unsigned 32-bit value, before an IO_READ(TIME_HIGH), 
> which
> +     *   returns a signed 32-bit value, corresponding to the higher half of 
> the
> +     *   full value.
> +     */
>      switch (offset) {
>      case RTC_TIME_LOW:
> -        r = goldfish_rtc_get_count(s) & 0xffffffff;
> +        r = goldfish_rtc_get_count(s);
> +        s->time_high = r >> 32;
> +        r &= 0xffffffff;
>          break;
>      case RTC_TIME_HIGH:
> -        r = goldfish_rtc_get_count(s) >> 32;
> +        r = s->time_high;
>          break;
>      case RTC_ALARM_LOW:
>          r = s->alarm_next & 0xffffffff;
> diff --git a/include/hw/rtc/goldfish_rtc.h b/include/hw/rtc/goldfish_rtc.h
> index 16f9f9e29d..9bd8924f5f 100644
> --- a/include/hw/rtc/goldfish_rtc.h
> +++ b/include/hw/rtc/goldfish_rtc.h
> @@ -41,6 +41,7 @@ typedef struct GoldfishRTCState {
>      uint32_t alarm_running;
>      uint32_t irq_pending;
>      uint32_t irq_enabled;
> +    uint32_t time_high;
>  } GoldfishRTCState;

You need to add the new field to goldfish_rtc_vmstate, and increment the 
version.


r~