[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-trivial] [Qemu-devel] [PATCH] target-moxie: replace target_phy
Re: [Qemu-trivial] [Qemu-devel] [PATCH] target-moxie: replace target_phys_addr_t with hwaddr
Fri, 17 May 2013 10:26:21 +0200
Mozilla/5.0 (X11; Linux x86_64; rv:17.0) Gecko/20130329 Thunderbird/17.0.5
Am 15.05.2013 10:23, schrieb Peter Maydell:
> On 15 May 2013 07:04, Hu Tao <address@hidden> wrote:
>> target_phys_addr_t has been already replaced by hwaddr, but this
>> one is introduced after.
>> Signed-off-by: Hu Tao <address@hidden>
> Reviewed-by: Peter Maydell <address@hidden>
> This doesn't cause compile errors because it's in a bit
> of code that can never get compiled (it's inside a
> CONFIG_USER_ONLY block but there is no moxie-linux-user
> target in configure).
A similar issue had come up before and I don't remember seeing a clear
Are you planning to actually implement moxie-linux-user and enable it by
default, so that we can catch any errors? Or should we rather drop any
such unused CONFIG_USER_ONLY code from target-moxie?
SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany
GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer; HRB 16746 AG Nürnberg