Re: [Qemu-trivial] [PATCH 1/1] arm: virt: change GPIO trigger interrupt to pulse

[Shannon Zhao]

On 2016/1/29 22:35, Wei Huang wrote:
> 
> On 01/29/2016 04:10 AM, Shannon Zhao wrote:
>> > Hi，
>> > 
>> > This makes ACPI work well but makes DT not work. The reason is systemd or
>> > acpid open /dev/input/event0 failed.
To correct, systemd or acpid open /dev/input/event0 successfully but it
waits for events and when we input "system_powerdown", it doesn't get
the event.

> So the interrupt could be injected and
>> > could see under /proc/interrupts but guest doesn't have any action. I'll
>> > investigate why it opens failed later.
> That is interesting. Could you try it with the following? This reverses
> the order to down-up and worked on ACPI case.
> 
> qemu_set_irq(qdev_get_gpio_in(pl061_dev, 3), 0);
> qemu_set_irq(qdev_get_gpio_in(pl061_dev, 3), 1);
If we don't input "system_powerdown" during guest booting(before device
driver load), current QEMU with above codes could work for DT. But if we
input "system_powerdown" during guest booting, guest has no action when
we input "system_powerdown" again after guest booting completely.
I add dc->reset for pl061 but get the same result.

Below is the output of acpid:

./acpid -l -n -d
input layer /dev/input/event0 (gpio-keys) opened successfully, fd 4
inotify fd: 5
inotify wd: 1
RTNETLINK1 answers: No such file or directory
acpid: error talking to the kernel via netlink
netlink opened successfully
acpid: starting up with netlink and the input layer
parsing conf file /etc/acpi/events/powerbtn
acpid: 1 rule loaded
acpid: waiting for events: event logging is on

It will stuck here even if we input "system_powerdown".

Below is the right output when we input "system_powerdown".

./acpid -l -n -d
input layer /dev/input/event0 (gpio-keys) opened successfully, fd 4
inotify fd: 5
inotify wd: 1
RTNETLINK1 answers: No such file or directory
acpid: error talking to the kernel via netlink
netlink opened successfully
acpid: starting up with netlink and the input layer
parsing conf file /etc/acpi/events/powerbtn
acpid: 1 rule loaded
acpid: waiting for events: event logging is on
acpid: received input layer event "button/power PBTN 00000080 00000000"
acpid: rule from /etc/acpi/events/powerbtn matched
acpid: executing action "/etc/acpi/powerbtn.sh"

Thanks,
-- 
Shannon