[Quilt-dev] [PATCH] setup: Align --fast on --slow for series files

[Jean Delvare]

Remove the requirement to unpack the source tree manually when using
the fast mode of quilt setup and the parameter is a series file.
Instead, let --fast behave exactly like --slow, so that both modes
can be used interchangeably.

Signed-off-by: Jean Delvare <address@hidden>
---
Not sure what I had in mind back then, to get the behavior wrong AND
document it as such... Sorry about that.

 quilt/setup.in |    7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

--- quilt.orig/quilt/setup.in   2019-03-11 15:38:28.185741055 +0100
+++ quilt/quilt/setup.in        2019-03-11 15:47:33.253573117 +0100
@@ -295,8 +295,7 @@ Initializes a source tree from an rpm sp
 
 --fast Use an alternative, faster method to process the spec file. In this
        mode, rpmbuild is told to generate a working tree directly in the
-       target directory. If the input is a series file, it is assumed that
-       all archives have been extracted manually beforehand.
+       target directory.
 "
                exit 0
        else
@@ -426,7 +425,9 @@ case "$1" in
        ;;
 esac
 
-if [ -z "$QUILT_SETUP_FAST" ]
+# If running on a spec file in fast mode, the source tree is already unpacked;
+# in all other cases, we must prepare the source tree now
+if [ -z "$QUILT_SETUP_FAST" -o -n "$series_file" ]
 then
        # Make sure that unpacking will not overwrite anything
        check_for_existing_directories || exit 1


-- 
Jean Delvare
SUSE L3 Support