Re: [Simulavr-devel] New 0.0.13-pre1 works well

[reinhard . jessich]

On Fri, 04 Jan 2002, Theodore A. Roth wrote:
> On Fri, 4 Jan 2002, address@hidden wrote:
> 
> :)I have discoverd, that it is possible to restart a simulation without
> :)rerun of simulavr. I used the load command to do this. This will set
> :)the registers including the PC. gdb will set the PC to 0 with this
> :)command.
> 
> Gdb doesn't send anything that anything to the remote that will let it 
> know that you want to reset the simulavr's state. Something needs to 
> happen such that gdb can send a reset signal. Using 'load' is not enough. 
> For instance, I can see that once I run up to a breakpoint and then issue 
> a 'load' command from gdb, the sim's sreg value is unchanged. Not really 
> what you want. I've got some ideas, see below.
I though this isn't enough.

<snip>

> the sim. This works well for me, but I'm not doing any serious debugging 
> of avr programs with the simulator.
If you don't use the simulator, why are you programming one?

Regards,
  Reinhard

-- 
 Ing. Reinhard Jessich              mailto: address@hidden
 A-1190 Vienna, Goergengasse 2/2/1  phone: +43/1/3692600
 http://members.telering.at/jessich mobile: +43/664/1735439