[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
MUX2?
From: |
Al Arduengo |
Subject: |
MUX2? |
Date: |
17 Aug 2001 08:19:14 -0500 |
User-agent: |
Gnus/5.0808 (Gnus v5.8.8) XEmacs/21.4 (Developer-Friendly Unix APIs) |
I sure hope this is not a faq. I searched the docs I have but could
not find any mention. I am experimenting with schematic view usage and
created a version of a DCA encoder. One of the components used is a
2->1 mux. I connected two inputs, an output and a select. When I try to
run a simulation on the whole contraption, I get an error in the
message window reporting that MUX2 is an unknown model. I inspected
the VHDL and the component and node definitions are there with the
inputs and output correctly named. The select, however, is called
UNKNOWN###### where ###### is a number. I assume it is called this
because of the fact that it is a bus input with no name but is
connected to a named wire. Anyway, is there anything I should know
specifically about muxes or perhaps the use of bus to wire connection?
Strangely, for some time an xnor2 I used was also complained about
just like the mux2 but now, after recompiling electric, it seems to
be acceptable in the vhdl view.
My thanks for any help offered.
-Al
--
-Al Arduengo
------------
"Actual courtroom exchange: Q: Mr. Slatery, you went on a rather
elaborate honeymoon, didn't you? A: I went to Europe, Sir. Q: And
you took your new wife?"