On 09/23/2013 03:54 PM, Ed wrote:
On 09/23/2013 11:40 AM, John wrote:
Still trying... on fresh cold boots the last two mornings, "ps -A" shows
no cwdaemon running. (Everybody probably knows this, but I had to try it
anyway: starting Xlog does not start cwdaemon.) I started cwdaemon with
"sudo /usr/sbin ./cwdaemon". Another "ps -A" then shows it running.
Xlog's keyer continues not to function.
Have you checked your bios to make sure the parallel port is
configured correctly ? If not, cwdaemon may not run.
Ed W3NR
Thank you for your patience, Ed. Yes, I checked that a couple of days
ago, and as far as I can tell, it looks OK. From the BIOS notes I took:
Par port adr: 378; Mode ECP; IRQ7; DMA channel DMA3.
There is nothing actually plugged into the parallel port because I
haven't yet fabricated the transceiver cable. I didn't figure that
would keep the daemon from producing a sidetone.