Re: persistent install failures on HP Omnibook 4100

[Eric Buddington]

On Fri, May 25, 2001 at 08:01:33AM +0900, OKUJI Yoshinori wrote:
> First of all, don't use the command "install", unless you are familiar
> with GRUB internals, as described in the manual. Obviously, you don't
> know how the command works, since you didn't specify the `p' option,
> so use the command "setup" instead.

Yes, this worked - looks like it was the 'd' option I needed (which I
hadn't used in the past). I was used to omitting 'p' on trial stage1/2
installs since I didn't care if stage2 found its config. I wasn't used
to using stage1.5.

Thanks,

Eric