|
Hello all,
I am running some simple tests with some E310/E312 radios and would like to set one up to receive on two channels simultaneously. How would I go about doing this using the UHD:USRP Source block? I have no problem receiving on a single channel, but when I
try to set up the block to have two channels, I get a, "Runtime Error: port number 1 exceeds max of 0."
I am rather new to the E310/E312, and I'm testing them out over networked mode rather than embedded. I have the device set up with a static IP address, which is configured in the Device Address box. What would be the basic parameters needed to set up an E310
to receive on two channels? I know the two RX channels would share the same LO, so I have the center frequency set to the same value for Ch0 and Ch1. I'm
using GRC 3.8 and UHD 4.1.0.
I appreciate any help with this. Thanks!
|