Re: Receiving on two channels with E310/E312

[Lipski, Michael Victor]

I tried both options; "A:A A:B" was invalid; it seems to accept "A:0 A:1", except that it gives me the same error message: "Runtime Error: port number 1 exceeds max of 0." 

Everything works fine with a single receive channel.  I have also tried streaming a single receive channel from two different E310s, which works just fine as well.  As soon as I try to add a second Rx channel, the flowgraph stops working.

---

From: Discuss-gnuradio <discuss-gnuradio-bounces+mvl5023=psu.edu@gnu.org> on behalf of Lipski, Michael Victor <mvl5023@psu.edu>
Sent: Wednesday, July 27, 2022 12:04 PM
To: GNU Radio Mailing List <discuss-gnuradio@gnu.org>
Subject: Receiving on two channels with E310/E312

 

Hello all,

I am running some simple tests with some E310/E312 radios and would like to set one up to receive on two channels simultaneously.  How would I go about doing this using the UHD:USRP Source block?  I have no problem receiving on a single channel, but when I try to set up the block to have two channels, I get a, "Runtime Error: port number 1 exceeds max of 0." 

I am rather new to the E310/E312, and I'm testing them out over networked mode rather than embedded.  I have the device set up with a static IP address, which is configured in the Device Address box.  What would be the basic parameters needed to set up an E310 to receive on two channels?  I know the two RX channels would share the same LO, so I have the  center frequency set to the same value for Ch0 and Ch1.  I'm using GRC 3.8 and UHD 4.1.0.

I appreciate any help with this.  Thanks!