Re: [Gluster-devel] glusterfs with vservers

[Geoff Kassel]

I'd like to second this. I've set up GlusterFS successfully between a VM and 
its host in the past. The main issue I had was a clock drift issue seemingly 
affecting timely network communication between the two.

I found that setting a comparatively very low timer frequency in the VM (i.e. 
100Hz versus 1000Hz on the host) seemed to keep the host able to process VM 
clock ticks while keeping its own clock up to date.

This was using VMWare. If you're using a different virtualization technology, 
this may not apply to you.

Kind regards,

Geoff Kassel.

On Sat, 22 Nov 2008, Dan Parsons wrote:
> I think you're probably already aware of this, and I'm not sure it's
> the cause of your problem, but I'd like to chime in and say that
> networking between VMs and the host that runs the VM can sometimes be
> very tricky in non-obvious ways.
>
>
> Dan Parsons
>
> On Nov 21, 2008, at 9:32 AM, Anand Avati wrote:
> >> B)
> >>
> >> 2008-11-20 17:40:32 W [client-protocol.c:280:client_protocol_xfer]
> >> trans:
> >> attempting to pipeline request type(2) op(4) with handshake
> >> 2008-11-20 17:40:32 E [fuse-bridge.c:2702:init] glusterfs-fuse:
> >> fuse_mount
> >> failed (Transport endpoint is not connected)
> >>
> >> 2008-11-20 17:40:32 E [glusterfs.c:547:main] glusterfs:
> >> Initializing FUSE
> >> failed
> >
> > The above error means there is a stale mount on /mnt. umount /mnt
> > and try
> > again. Not quite sure about your other errors, seems not to be
> > glusterfs
> > related. Do you know if having support for glusterfs client to
> > bind() to a
> > specific local IP address will resolve this issue?
> >
> >
> > avati
> > _______________________________________________
> > Gluster-devel mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/gluster-devel
>
> _______________________________________________
> Gluster-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/gluster-devel