[gNewSense-users] Re: gNewSense-users Digest, Vol 40, Issue 25

[Karunakaran .M]

When I switched over to gNewSense from Ubuntu, I did fix this problem by the first sugessted method. After an year or so, when I tried out taking printer output now, I am noticing this problem. 

What I mean is printing was possible in gNewSense earlier, with the same community edition of Qcad. 

Lot of updates/ software addition/ software deletion were made from gNewSense repository in the past one year by me.  I have a doubt on QT updates. 

Ref this thread - http://www.linuxquestions.org/questions/linux-software-2/printing-from-qt-apps-using-cups-solved-363383/?highlight=no+printer+qcad

Karunakaran

Karunakaran .M schreef:
> I have installed Qcad from the gNewSense repository through Synaptic Package
> Manager and the Version 2.0.5.0(Community Edition)
>
> Printer is listed - both PDF as well as the other one, laser.
>
> But in the print window, three modes are available viz 'Print All', 'Print
> Selection' and 'Print Range'. In this I am not able to choose 'Print
> Selection' mode, without which printing is not possible at all.

Indeed, "Print Selection" is grayed out here too. Maybe it only works in
the non-free version of QCad. "Print All" gives me output, but not as
"Print Preview" shows it. Maybe someone on the QCad forums knows what's
going on with this.