Re: 6160 noob

[Marc Williams]

Thanks for the reply.  As you suggested, I tried changing the baud rate
with the same results.  It's just not communicating with the phone for
some reason.


On Thu, 2004-05-06 at 08:48, Diego Betancor wrote:
> The baud rate must be at 9600,
> 
> but the 6160 is a tdma phone that uses mbus-2, and as far as I know, not
> much is known about them; there are not many known commands in this models.
> 
> Does anybody know of a TDMS/CDMA phone that uses fbus?
> 
> 
> 
> Diego
> 
> 
> At 08:24 PM 5/5/04 -0500, you wrote:
> >I'm having problems getting to first base with Gnokii and my ancient
> >6160.  Maybe I'm missing something obvious and someone can help me spot
> >it.  This is the problem.
> >
> >address@hidden etc]# gnokii --identify
> >GNOKII Version 0.6.1
> >Telephone interface init failed: Command timed out.
> >Quitting.
> >
> >According to seteserial, both my comm ports are working fine.  I've
> >tried both ports with gnokii.  I use the dau9p cable.  I have left my
> >gnokiirc file as default except for:
> >port = /dev/ttyS1 (I adjust depending on which comm port I use)
> >model = 6160
> >serial_baudrate = 115200
> >
> >I have tried setting connection=dau9p without luck.
> >
> >Any suggestions welcome.  Please!
> >
> >
> >
> >
> >_______________________________________________
> >gnokii-users mailing list
> >address@hidden
> >http://mail.nongnu.org/mailman/listinfo/gnokii-users
> > 
> 
> 
> _______________________________________________
> gnokii-users mailing list
> address@hidden
> http://mail.nongnu.org/mailman/listinfo/gnokii-users
>