Re: Help needed to configure and compile gpsd to run on a Raspberry Pi 4 and NOT use systemd

[Mick Durkin]

Hi Gary,

Here is a fresh attempt.

It takes a bit of time to sort as my son (Patrick) is in Berlin but I
am in the UK.

We downloaded a fresh clone from gitlab then rebooted the Pi.
Immediately after the reboot we ran "dmesg". We then printed
"/boot/firmmware/config.txt", followed by running "scons"  and "scons
install".

We ran the daemon, as requested using "gpsd -n -D 4 /dev/ttyS0", but
no output was generated. I wonder if the output was going to somewhere
other than the ssh session we were using?

We then ran "gpsdebuginfo".

All the session is logged and attached in "build.log".

After this we killed gpsd and retried with a log level of 9, but still
go no output.

BR

Mick

build.log
Description: Binary data