Re: [Help-gnucap] strange error message if a subcircuit definition is wrong

[Werner Hoch]

Hi Al,

On Sonntag, 4. November 2007, al davis wrote:
> The real problem in your case is that you left out the ".ends"
> on your subckt, so it appears that the main circuit is part of
> the subcircuit.  Therefore there is no main circuit.
> There was no warning about this because the ".end" at the
> end of the file is close enough to .ends (and accepted by some
> Spice versions).

Oh thanks, I haven't noticed that error. I just was so fixed to the head 
of the subcircuit file where the subcircuit name is the same than the 
model name.

Then of course the given error message is correct.

Regards
Werner