[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Help-gnucap] Can't assign diode models in batch mode
From: |
Anthony Anconetani |
Subject: |
[Help-gnucap] Can't assign diode models in batch mode |
Date: |
Tue, 17 Feb 2009 15:02:09 -0600 |
Hello everyone,
I hope you all are doing well. This is my first time posting. I've just
started using gnucap this past week.
Here is my question. I'm trying to read in a netlist and commands in batch
mode. I have a file that called test_schematic2.sim.
The file contains:
.model 1N414 D IS=2e-14
Vcc 1 0 5
Dx 1 10 1N414
Dy 10 20 1N414
Dz 20 30 1N414
Rd1 10 0 1k
Rd2 20 0 1k
Rd3 30 0 1k
.print dc v(10) v(20) v(30)
.dc Vcc 0 5 0.5 >eg6.dat
.end
I then run:
>gnucap -b test_schematic2.sim
I do not receive the output file eg6.dat.
If I go into gnucap and pull the file in as follows:
gnucap> <test_schematic2.sim
I get the following message:
.model 1N414 D IS=2e-14
Dx: can't find model: 1N414
However, I can generate the model from inside of gnucap by using the build
command.
Can you tell why I cannot get gnucap to recognize the diode model through
the batch mode?
Thanks, and I hope I'm not wasting your time with something obvious.
-Anthony Anconetani
- [Help-gnucap] Can't assign diode models in batch mode,
Anthony Anconetani <=