Re: How can i get/extract single values from a .mat-file

[Francesco Potortì]

>So what i would like to do now (by the way I'm also looking for a Dymola
>solution, as i'm not sure if octave supports Dymola created mat-files) 

First of all, try it.  See if you can load your mat files in Octave.

>look for a possibility to get only the last values for 3 parameters (the
>mentioned u and j plus an unknown variable T) of each of these files to
>create a 3d-plot showing the dependencies between these 3 parameter values.

I am not sure I understand what you need.

>BTW: I'm using octave 3.2.4 (on ubuntu 12.04) and until now i found lots of
>possible matlab commands which may help but don't work with octave.

Which ones?

-- 
Francesco Potortì (ricercatore)        Voice:  +39.050.315.3058 (op.2111)
ISTI - Area della ricerca CNR          Mobile: +39.348.8283.107
via G. Moruzzi 1, I-56124 Pisa         Fax:    +39.050.315.2040  
(entrance 20, 1st floor, room C71)     Web:    http://fly.isti.cnr.it