Re: How can i get/extract single values from a .mat-file

[Y. Chaffai]

Francesco Potortì wrote
>>So what i would like to do now (by the way I'm also looking for a Dymola
>>solution, as i'm not sure if octave supports Dymola created mat-files) 
> First of all, try it.  See if you can load your mat files in Octave.

Ok here's what i get after loading a so created file:


hm... well what i can definitely say (after transforming the file into
csv-format) is that i have 3 variables/Parameters stored in 502 simulation
steps,

And about the possibly helpful commands:
uigetfile % to read the mat file...but how? 
uigetdir % to access the directory where the files are stored

And what i want is a kind of 3d-profile of how does the variable T2 depends
on changes in the parameters u and j :)



>look for a possibility to get only the last values for 3 parameters (the
>mentioned u and j plus an unknown variable T) of each of these files to
>create a 3d-plot showing the dependencies between these 3 parameter values.

I am not sure I understand what you need.

>BTW: I'm using octave 3.2.4 (on ubuntu 12.04) and until now i found lots of
>possible matlab commands which may help but don't work with octave.

Which ones?

-- 
Francesco Potortì (ricercatore)        Voice:  +39.050.315.3058 (op.2111)
ISTI - Area della ricerca CNR          Mobile: +39.348.8283.107
via G. Moruzzi 1, I-56124 Pisa         Fax:    +39.050.315.2040  
(entrance 20, 1st floor, room C71)     Web:    http://fly.isti.cnr.it
_______________________________________________
Help-octave mailing list
Help-octave@
https://mailman.cae.wisc.edu/listinfo/help-octave





--
View this message in context: 
http://octave.1599824.n4.nabble.com/How-can-i-get-extract-single-values-from-a-mat-file-tp4644360p4644375.html
Sent from the Octave - General mailing list archive at Nabble.com.