Re: displaying an image

[lana frankle]

On Sat, Sep 12, 2015 at 1:00 PM, Nicholas Jankowski <address@hidden> wrote:

On Sat, Sep 12, 2015 at 2:56 PM, lana frankle <address@hidden> wrote:

On Sat, Sep 12, 2015 at 12:07 AM, Andy Buckle <address@hidden> wrote:

On 12 September 2015 at 06:02, lana frankle <address@hidden> wrote:

Octave is giving me the following error while I'm trying to do 2-D plotting:

>> y=((x+5).^2)/(4+3*x.^2)

y =  1.5625

>> figure plot(X,Y)

error: figure: N must be figure handle or figure number

error: called from

    figure at line 67 column 7

I'm not sure what it means.  Where do I put the "N"?

you are sending plot as an argument to figure. you probably want to put them on separate lines

figure

plot(X,Y)

The error is coming from figure, so in general you should look at the help for the figure function. like this

help figure

it explains that calling figure with an argument N is useful when you have multiple figures open and you want to switch back to one created earlier.

--

/* andy buckle */

now it's telling me "error: 'x' undefined near line 1 column 5".

I'm not sure the code I'm entering prior to the line where I define y is exactly the same as it was yesterday (I didn't save the code in the command window) right now it's 

if x>=3 and x=<5: 

well, hard to guess without seeing the actual code you're using. Note you can use a text editor or the built in editor to write your commands in a script file, (one command per line just like you'd type on the command line). then save it as a filename.m file, and you can run the script by typing 'filename'.  this allows you to edit code you run more than once, get into programming, etc.

Assuming the code above is like what you're running, you're defining x and y but trying to plot X and Y.  Octave is case sensitive so those are not the same.

> right now it's 

> if x>=3 and x=<5:

I'm not sure what you mean by this as it has nothing to do with the code listed above.

It's not just the case-sensitive thing though because that error message shows before I try to plot.  x>=-3 and x=<5 was given in the problem I'm trying to work from the book "MATLAB: An Introduction with Applications".  The error shows right after I define y.  My code is:

if x>=-3 and x=<5:

y=((x+5).^2)/(4+3*x.^2)

error: 'x' undefined near line 1 column 5

#and once that's resolved, I'll want to do

figure

plot(X,Y)

(will I need a semi-colon after figure?)