Hi all,
I did use ATmega168 PPM encoder before and it seems to be damaged now. So I ordered a newer one that is ATmega328. I am confused a bit, it is not clear how to wire it?! Three wires (+,-, signal) goes to the ap board, for another wires there is one +, one - , and 8 holes for the signals. I found this picture http://paparazzi.enac.fr/wiki/Image:Ppzppmencsetup.jpg and I am not sure now, how should I do a wiring. In 168 version each of the channels had power, ground and signal which are going to R/C receiver. Does it mean here that the R/C receiver will be powered just from one wire with one ground wire?! , and for other channels signal wires must be connected only?!
Please, I need some help with it. I have not found any instructions how to do it.
It would be nice to have a better picture with some instructions to it. Just sent it to my private e-mail if you have some or may be a link.
Thank you.
Roman
Bristol Institute of Technology
University of the West of England
Aerospace Systems Engineering
e-mail: address@hidden
tel. +44 (0) 7760806643
________________________________________________________
Please consider the environment before printing this email.