Re: [Paparazzi-devel] Powering Lisa/M 2.0

[Balazs GATI]

Perhaps you can power both rail with the same BEC.

Regards,
 Balazs

2014.05.04. 1:28 keltezéssel, Dylan Brunello írta:
> Thanks Piotr and Chris.
>
> On Sunday, 4 May 2014, Chris <address@hidden
> <mailto:address@hidden>> wrote:
>
>     No problem at all if you don't parallel the output of 2 or more BECs.
>     Sometimes linear BECs (switchmode never) can be paralleled but this
>     is not a good practice in any case.
>     In other words if you use more than one BEC in a split load
>     configuration but make sure that their + rail is not paralleled.
>     Chris
>
>     On 05/03/2014 01:59 PM, Dylan Brunello wrote:
> >     Hello,
> >
> >     I have a Lisa/M 2.0 configured with the default power jumpers. I'd
> >     like to power everything in the system from a single battery (3S
> >     LiPo). The plan is to power the servo rail using the 5V BEC on the
> >     ESC. Is it safe to connect an additional 5V BEC to the battery and
> >     use that to power the Lisa and peripherals? My concern is the two
> >     BECs on the one battery. Any thoughts regarding powering the
> >     system in this fashion?
> >
> >     Cheers,
> >     Dylan
> >
> >
> >     _______________________________________________
> >     Paparazzi-devel mailing list
> >     address@hidden  <javascript:_e(%7B%7D,'cvml','address@hidden');>
> >     https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

--
Balazs GATI, PhD
associate professor
     Department of Aeronautics, Naval Architecture and Railway Vehicles
     Budapest University of Technology and Economics

Address:   Budapest
          Stoczek u 6. J. ép. 423
          1111
Tel:       +(36)-1-463-1960
Fax:       +(36)-1-463-3080
Homepage: http://vrht.bme.hu/