Re: [Tlf-devel] S&P/RUN mode confusion

[Ed]

On 12/22/2013 01:10 PM, Ervin Hegedüs - HA2OS wrote:
> Hello,

> S&P_TU_MSG=

Your missing the message that goes in the above. Move what you have in 
the ALT_3 and it should now work.

> ALT_3=CFM ++5NN-- #

> But when I hear a station, and type callsign, on ALT+3 Tlf send
> the ALT_3 message ("CFM 5NN SERIAL"), but when I press the enter
> to save the QSO, Tlf send my callsign again - and I don't know
> why.

As Above.

> What I'm missing, and what is the correct way to use the two
> modes of Tlf?

Use  + to switch between RUN & S&P. In S&P remember the 2nd Enter sends 
th TU message. Use F2 to repeat your call till the RUN station calls you.

> On the previous contest, I only used RUN mode, but CQ_TU_MSG and
> S&P_TU_MSG were set up as empty string, and when I type an ENTER
> after I typed callsign, Tlf just save the QSO "silent".

That's because the 2 strings were empty. All of this I would imagine has 
been hard coded by Rein. But it works and works well. But you cannot 
change the Enter sequence in either RUN or S&P.

I would have copied the template rules file and change only what is 
needed. I normally do not change the macros or the TU messages.

Ed W3NR

Don't forget  \  logs the entry quiet with no CW output.