field output size

[Lesage,Anne Cecile J]

Dear all

 

I am using python scripting with getfem

 

I have a mesh with 54026

I output the results in a vtu format with the following script lines

 

mfoutb = gf.MeshFem(meshb)

mfoutb.set_classical_discontinuous_fem(2)

 

   mfoutb.export_to_vtu("PoroEResect25brain_%i.vtu" % it,

                      mfub, md.variable("ub"), "Displacements",

                      mfpb, md.variable("pb"), "Pressure")

 

when I save the spreadsheet of the results with paraview, I can the results on 2646060

Ideally I would like to have the results only on the 54026 nodes

Is there a way to correct my definition of mfoutb that corrects that?

 

I am preforming an inverse method on the material parameter typically on 700+ simulations, I need my results files to be smaller

 

Thank you

Regards

Anne-Cecile

The information contained in this e-mail message may be privileged, confidential, and/or protected from disclosure. This e-mail message may contain protected health information (PHI); dissemination of PHI should comply with applicable federal and state laws. If you are not the intended recipient, or an authorized representative of the intended recipient, any further review, disclosure, use, dissemination, distribution, or copying of this message or any attachment (or the information contained therein) is strictly prohibited. If you think that you have received this e-mail message in error, please notify the sender by return e-mail and delete all references to it and its contents from your systems.