Re: gnokii and Nokia Card Phone RPM-3 GSM900/1800

[Pawel Kot]

Hi,

On Wed, Jul 1, 2009 at 10:39, Vieri<address@hidden> wrote:
> Are you deducing it may be a timing problem because of the "ERROR" response 
> to the ATE1 command sent right after receiving a response to the ATZ command?
> So are you suggesting I "sleep" a little right after receiving the response 
> to ATZ and before sending ATE1?

The sequence is:
write: [ATZ<cr>]
read : [ATZ<cr><cr><lf>> ]
write: [ATE1<cr>]
read : [ERROR<cr><lf>]
write: [AT+CMEE=1<cr>]
read : [ATE1<cr><cr><lf>OK<cr><lf>]
write: [AT+GMM<cr>]
read : [AT+CMEE=1<cr><cr><lf>OK<cr><lf>]

Indeed, ERROR may go in response to ATZ command, but the problem is
that it goes just after ATE1 command being send and not before it.

take care,
-- 
Pawel Kot