On 2013-07-08, at 10:50 PM, Jim Busser <address@hidden> wrote:
Sorry if it was explained in an earlier thread, but
2. In the second attached screenshot
Measurements - Group by panel
the option has been used to "Group by panel" but the behaviour seems unusual in two ways.
Firstly, some of the same information is shown twice, once above, and once as part of what seems to be the "unfiltered" set of test results.
--> was this intended?
--> if yes, then this is not as much "Grouping" as it is pre-pending an extra instance of a subset of the values values -- those values that form part of the panel of interest -- *above* a full copy of the unfiltered results. Would it be better to make
this function as a filter, showing *only* those tests that are members of the panel (in which case the label would become 'Filter on panel:') or, -- if it is desired to show both the panel information and, below it, the unfiltered information -- to change
the label from
Group by panel:
to
Spotlight on panel:
(or even 'Filter on panel:' despite preserving the unfiltered results showing below the filtered ones?)
PS - if all among the tests {CRP, RBC, WBC, PLT} form part of
EML sep screen
then why do only two of them appear in the top portion of the display, while all 4 appear in the bottom of the display?
-- Jim