[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Gnump3d-users] Re: still can't get gnump3d to install on nslu2

From: Onur Akgün
Subject: [Gnump3d-users] Re: still can't get gnump3d to install on nslu2
Date: Tue, 12 Sep 2006 13:00:03 -0400


At the time when I was trying to install gnump3d, I've also struggled
with this problem, which is actually not related with gnump3d. Problem
is you don't have necessary tools to make/make install; yet :o)

As far as I remember, you should install coreutils package (ipkg
install coreutils). After that,  just try (make install) again.

Hope it helps,


---------- Forwarded message ----------
From: "Cle Crape" <address@hidden>
To: address@hidden
Date: Mon, 11 Sep 2006 15:43:24 -0500
Subject: [Gnump3d-users] still can't get gnump3d to install on nslu2
I followed the wiki on
and I looked at the thread by Ian Barton and Steve Kemp but I still can't
gnump3d to compile.  Any suggestions would be appreciated.

Here's a bit of system info:

Perl info:
-bash-3.1# perl -e 'for my $i ( @INC ) { print $i . "\n"; }';

I modified the Makefile like so:
LIBDIR      = /opt/lib/perl5/site_perl

Then when I run "make install" I get this:
-bash-3.1# make install
 install -d /etc/gnump3d
make: install: Command not found
 make: *** [install] Error 127

Gnump3d-users mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]