Re: [Linphone-users] No Incoming Calls.

[Lorenzo Corgiat Mecio]

Hi Paul,

I am facing a similar issue.
I was using Cisco spa303 on linphone.
It has been working fine since about two weeks ago when I stopped
getting incoming calls as well on all my hardphones.
I DID NOT change anything on the network or phone configuration.
I also tried other networks and fresh factory-reset phones with
different software versions without luck.
Devices register fine and can make calls.
For experiment I setted up a classic vintage Grandstream 2000 phone
and that seems to work.
I say it seems because calls take ages to get through. I mean, I call
and the receiving phone can sometimes take 10 seconds to start
ringing.
Other SIP providers are working fine with both setups and calls are
incoming in less than a second as usual.
I opened a topic here a few days ago but no answers so far...
I get on the phone I am calling from "User hasn't been found".
Settings are UDP.

Thank you

Skinoku

Il giorno gio 15 set 2022 alle ore 19:34 Paul Flint <flintp@gmail.com>
ha scritto:
>
> Hi, Newbie here, long time user of Obihai ATAs, used to doing my own setup.
>
> Here's a problem I can't seem to solve:
>
> I set up a Service Provider and Voice Service for a new Linphone account on 
> an Obi 200. It registers fine and I can initiate SIP calls to Voip.ms, 
> callcentric, and SIPBroker.
>
> I can't call it, though. I get 403 and 404 errors from voip.ms, callcentric, 
> and 2 different ways from SIPBroker: a) using the **275 route from 
> callcentric, and b) dialing from a PSTN line (in both cases using the *8954 
> proxy code for linphone).
>
> When dialing from an Obi 202, I put the URI in a speed dial slot.
>
> So, am I an idiot and missing something obvious, or is something subtle going 
> on?
>
> Thanks in advance.
>
>   -- Paul.
> _______________________________________________
> Linphone-users mailing list
> Linphone-users@nongnu.org
> https://lists.nongnu.org/mailman/listinfo/linphone-users