[Octave-bug-tracker] [bug #65421] patch fails to render if cdata is specified before geometry in property/value calling form

[Markus Mützel]

Follow-up Comment #39, bug #65421 (group octave):

The attached patch changes the recently added "programming notes" for the
`patch` function:
* We probably shouldn't point users to the "cdata" property in a list that
also mentions "faces", "vertices", and "facevertexcdata". "cdata" should be
described in the section about the input "C" (or a reference to the "cdata"
property could be added there).
* I don't know where the advice to set all of the patch geometry properties
before setting any other properties comes from. I suspect that was inspired by
the last point in that list. Anyway, that point is confusing (and the truth
that is to it is covered in a later item).
* I assume that `facecentercdata` is a typo and it should say
`facevertexcdata` instead.

Does that change look good to you?


(file #55840)

    _______________________________________________________

Additional Item Attachment:

File name: bug65421-patch-doc-programming-notes.patch Size:1 KB
   
<https://file.savannah.gnu.org/file/bug65421-patch-doc-programming-notes.patch?file_id=55840>


    AGPL NOTICE

These attachments are served by Savane. You can download the corresponding
source code of Savane at
https://git.savannah.nongnu.org/cgit/administration/savane.git/snapshot/savane-cf05868ce827c9612cb6083f86556077b7ab06b3.tar.gz


    _______________________________________________________

Reply to this item at:

  <https://savannah.gnu.org/bugs/?65421>

_______________________________________________
Message sent via Savannah
https://savannah.gnu.org/