Quoting Arvind Ajoy <
address@hidden>:
> Dear Getfem users
>
> In my previous post, I had asked questions regarding the calculation of an
> (n-1) dimensional
> integral in a an n-dim problem.
> In pursuit of a solution to this, I was successful in creating a slice using
> the gf_slice('points', mesh m, mat P)
> function in the getfem-matlab interface. I now need to create a mesh from
> this slice.
>
> The documentation for the getfem-matlab interface doesnt seem to mention how
> one can create a mesh from
> a slice. However, the getfem++ documentation at
>
http://download.gna.org/getfem/doc/getfemuser/getfemuser_18.html#id2
> points out the following
>
"getfem::slicer_build_mesh<> (mesh
> &m) : In some (rare) occasions , it might be useful to build a mesh from a
> slice.
> Note however that there is absolutely no guaranty that the mesh will be
> conformal (although it is often the case). "
>
> I looked at the source code, but couldnt figure out how to use the
> getfem-matlab interface to create a mesh from
> a slice.
>
> Could someone kindly suggest how I can solve this problem?
>
> Regards
> Arvind
>